When George Vancouver sailed into the Strait of Juan de Fuca in 1792, one of the first sheltered anchorages he used was a long, deep inlet he named for his own ship, HMS Discovery. Today most people call it Discovery Bay. On the 1890 chart behind our board, it carries its older name: Port Discovery.
Two harbors on one sheet
Coast & Geodetic Survey chart No. 648, Port Discovery and Washington Harbor, Washington, pairs the long arm of Port Discovery with Washington Harbor, the smaller bay at the mouth of Sequim Bay to the west. Between them, the engraved title block floats in open space, with the Coast Survey seal above it. Points along the shore are named one by one: Clallam Point, Beckett Point, Carr's Point, Gibbs Point.
Who made it
The chart's notes list its authorities. Triangulation was done by George Davidson and J.S. Lawson between 1856 and 1870, topography by Lawson between 1868 and 1870, and hydrography in 1881, with the sheet published in June 1890 under Superintendent T.C. Mendenhall. You can see that care in the engraving: the stippled hillsides, the fine soundings, and the tide table and buoy key printed right on the sheet.
A sawmill-era bay
In the second half of the 1800s, Port Discovery was lumber country. A sawmill town grew up on the bay's western shore, and ships came in to load timber bound for distant ports. The chart reflects a working waterway, measured in detail for the vessels that used it.
From chart to cutting board
We print a landscape crop of chart 648 on an 8″ × 11″ tempered glass cutting board, in a warm sepia tone that suits the original engraving. See the Port Discovery 1890 cutting board, or browse the Port Townsend & Discovery Bay collection. Next door, read about Port Townsend in 1895.
Historical charts are decorative and not for navigation.